November 19, 2023
ForewordHi everyone, I'm Mr. Lin, setup method of Hikvision Elevator Wireless Network Bridge is very simple, let's go over main points together! TextElevator bridge configuration method
Reminder:
Drawbridges are packed in pairs and configured by default. To use them, you just need to install them correctly. If pairing fails/the indicator is off.
Note. The device is not activated and IP address is not changed, which does not affect use of bridge, but it is recommended to activate and change it for later maintenance.
1. Connection guide:
1. Guide for connecting a network bridge to a POE module (injector)
Reminder:
The POE module (injector) of wireless network bridge cannot supply power to camera, and cameras need an independent power supply. The module (injector) supplies power to wireless network bridge, and module's POE port (injector) is connected to bridge. The POE port of network bridge is powered and LAN port is connected to the camera or switch
Computer Room Connection:
Camera terminal connection:
Second, installation guide:
1. The "HIKVISION" bridge logo is facing each other at both ends and no occlusion in middle
2. Distance between bridge and wall more than 50cm
3. At least 2 meters between pairs of bridges of adjacent elevator shafts
Specific instructions:
