October 08, 2023
Today, I'll explain to you how big screen merge of base decoder on wall works. There are two ways to place built-in screen on wall, one is to work with web page and other is to work with SmartPSS client
(This article uses DH-NVD1205DH-4I-4K, SmartPSS client version 2.02 as an example)
Applicable models for large baselines:
DH-NVD0905DH-(-4I)-4K,
DH-NVD1205DH-(-4I)-4K,
DH-NVD1505DH-(-4I)-4K,
DH-NVD1805DH-(-4I)-4K,
DH-NVD2105DH-(-4I)-4K etc.
01. Webpage merge screen on wall1. The web page enters decoder normally and device is added normally (see previous article)
2. Set up a TV wall (merge screen)
1) New TV wall layout
Settings>Display management>TV wall configuration>Add TV wall and the TV wall layout setting interface will open
2) TV wall configuration
Set TV wall name, select split screen at bottom, if M*N is not selected, default is embedded screen, next step
3) Decode channel binding
Place each slot on appropriate screen to bind; or select splice screen (at this time, color of screen will turn dark yellow), click auto snap horizontal/vertical to quickly snap screen, click "Done"
4) ON status is enabled
3. Install screen on wall
Click on window to split, because all screens are combined into one integrated screen, so there is only one block, set screen split, and then drag device you want to window to upload to wall
Q: How to set up if you need to glue only part of screen?
A: After selecting split screen in TV wall configuration, select entire screen, color will turn dark yellow, click to cancel screen connection, and then select screen you want, form connected screen. should be regular, click "Splice" and click "One Step"
Rebind appropriate slot and finish
Status enabled
Enter TV wall interface, select split windows, split specified block (merge screen is a block) and place it on the wall
02. SmartPSS client fusion screen on wall
1. The device was added normally on the client
2. Enter TV wall interface, click TV wall to open it (Customer can automatically get TV wall after setting up web page)
3. Select a screen and drag it to desired screen to upload to wall, or select appropriate section below to upload to wall
Note. If you want to create a merge screen wall directly on client, click "+" on TV wall, and the TV wall layout setting interface
Set up name of TV wall, select number of screens and drag it to an empty space to fix it, then select screens you want to merge (hold down Ctrl key, left click to select screens), click merging , next step
Finish after binding decoder output channel
All screens must be linked to output channel of decoder, otherwise it cannot be completed, as shown in the figure below
Finally, drag screen directly onto wall in TV wall interface
